Restores a VNXe snapshot back to its source.

Note: This command is for VNXe3200 systems only.



Restore-EmcVnxeSnapshot -Snapshot <Vnx2eSnapshot> [-Force] [-Silent] [-WhatIf] [-Confirm] [<CommonParameters>]



-Snapshot <Vnx2eSnapshot>

Attributes: Required, Position: 1

Specifies the snapshot to restore.


-Force <SwitchParameter>

Attributes: Optional, Position: named

Suppresses any user prompts while running the cmdlet.


-Silent <SwitchParameter>

Attributes: Optional, Position: named

Turns off all the informational and verbose messages. However, it still displays errors.


-WhatIf <SwitchParameter>

Attributes: Optional, Position: named

Shows what would happen if the cmdlet runs. The cmdlet is not run.


-Confirm <SwitchParameter>

Attributes: Optional, Position: named

Prompts you for confirmation before running the cmdlet.



This cmdlet supports these common parameters: Verbose, Debug, ErrorAction, ErrorVariable, WarningAction, WarningVariable, OutBuffer, and OutVariable. Type get-help about_commonparameters for more details.



C:\PS>$snap = Get-EmcVnxeSnapshot TestSnap

Restore-EmcVnxeSnapshot -Snapshot $snap

Restores the specified snapshot back to its source.