Note the following after the upgrade:
- You must upgrade all of the protection
agents. This operation does not require a restart. For more
information, see Updating Protection Agents
- After upgrading the DPM Server and the
protection agents to DPM 2010, all of your data sources will
be marked as inconsistent. Upgrade the respective protection
agents, and then perform a consistency check.
- Reconfigure tape library sharing. For more
information, see Setting up Tape Library Sharing.
To perform the agent upgrade
Copy DPMAgentInstaller.exe and DPMAgentInstaller_x64.exe to a network share.
Logon to the protected servers and run the appropriate DPMAgentInstaller command on the protected servers.
To configure secondary protection
On the secondary DPM server, launch the DPM Agent Installation Wizard.
Select Install Agents.
Select the primary DPM servers that the secondary DPM protects.
Complete the agent installation.