You can use the following procedure to disable or enable an Active Directory connector.

To disable an Active Directory connector

  1. In the Service Manager console, click Administration.

  2. In the Administration pane, expand Administration, and then click Connectors.

  3. In the Connectors pane, select the Active Directory connector that you want to disable.

  4. In the Tasks pane, under the connector name, click Disable.

  5. In the Disable Connector dialog box, click OK.

To enable an Active Directory connector

  1. In the Service Manager console, click Administration, and then click Connectors.

  2. In the Connectors pane, select the Active Directory connector that you want to enable.

  3. In the Tasks pane, under the connector name, click Enable.

To validate the status change of an Active Directory connector

  1. Wait for about 30 seconds. Then, in the Service Manager console, click Administration, and then click Connectors.

  2. In the middle pane, locate the connector for which you have changed status, and then verify the value in the Enabled column.