Step 1-14: Configure the Configuration Manager 2007 R3 Site Boundaries

The Configuration Manager 2007 R3 client needs to know the boundaries for the site. Unless the site boundaries are specified, the client assumes that the computer running Configuration Manager 2007 R3 is in a remote site. Add a site boundary based on the IP subnet that WDG-MDT-01, WDG-REF-01, and WDG-CLI-01 use.

To configure the Configuration Manager 2007 R3 site boundaries

1. Click Start, point to All Programs, and then point to Microsoft System Center. Point to Configuration Manager 2007, and then click ConfigMgr Console.

2. In the Configuration Manager console navigation pane, go to Site Database/Site Management/NYC - New York City Site/Site Settings/Boundaries.

3. In the Actions pane, click New Boundary.

4. Complete the New Site Boundary dialog box using the information in Table 14, and then click OK.

Note For this sample, the site boundary is specified by network address. However, you can also specify site boundaries using an AD DS site name or an IP address range.

Table 14. Information Required to Complete the New Site Boundary Dialog Box

For this	Do this
Description	Type IP Subnet Boundary.
Type	Select IP subnet.
Network	Type network_address (where network_address is the network address of the subnet where the computers are installed).
Subnet mask	Type subnet_mask (where subnet_mask is the subnet mask of the subnet where the computers are installed).

5. Close any open windows.