GPUView Command-Line Options

You can control GPUView from a Command Prompt window. You can designate switches with either a minus sign (-) or a slash mark (/) followed by either the first character of the option or the full name of the option. The characters are not case sensitive.

All of the following commands perform the same operation:

Gpuview /s merged.etl
Gpuview -s merged.etl
Gpuview -Stats merged.etl
Gpuview /staTS merged.etl

Note that GPUView performs a limited amount of validation on command-line parameters. Therefore, ensure that the syntax of a command is correct to avoid unwanted side effects.

Also, when you issue command-line parameters, the file name, if it is included in the list of parameters, must always be last in the list. There is one exception to this file-name requirement. For more information about this exception, see Option: File.

The following sections describe the GPUView command-line options:

Option: Help

Option: Stats

Option: Limit

Option: File

 

 

Send comments about this topic to Microsoft

Build date: 8/22/2011

© 2011 Microsoft Corporation. All rights reserved.