Use the Summary page of the Create New Protection Group Wizard to confirm the settings of your protection group.
This page lists the settings you have selected. Confirm that the settings are correct, and then click Create Group to create the protection group. To change the settings, click Back.
Note that if you are modifying a protection group the following jobs will be cancelled. For more information about jobs that are cancelled when you modify a protection group, in the DPM Operations Guide, see Managing Performance (http://go.microsoft.com/fwlink/?LinkID=178445).
Servers
| Replication jobs | Archive jobs |
|---|---|
|
Configure protection |
Short-term and Long-term archive |
|
Synchronization |
Data set copy |
|
Consistency check |
Data set verification |
|
Shadow copy |
Recovery from tape |
|
Initial replication |
|
|
Recovery from shadow copy |
Clients
| Replication jobs | Archive jobs |
|---|---|
|
Configure protection |
Short-term and Long-term archive |
|
Shadow copy |
Data set copy |
|
Recovery from shadow copy |
Data set verification |
|
Recovery from tape |